Filter
Top Products
Getting started
8 Square ONE Splitter
Connecting to unbalanced equipment
Important:
We recommend that you only connect balanced devices to your Square ONE Splitter. However, if
you do have to connect unbalanced devices, we recommend that you use the Klark Teknik DN100
DI box to balance the signal first.
Ideally, you will be making the best use of the low-noise high-headroom balanced inputs of the Square ONE
Splitter by connecting to similarly balanced equipment. However, if you do have to connect to unbalanced
devices, the following wiring is recommended for best results.
Figure 3: I/O connections to unbalanced devices
Powering the unit
Switch the power on at the mains power outlet. (The Square ONE Splitter does not have a mains power
on/off switch.)
Your unit is now ready to operate.
Ground
+ve
-ve
Ground
-ve
+ve
Unbalanced device
1
3
2
2
1
Pin 1: Screen/Ground (not
connected at balanced end if ground
loops are generated)
Pin 2: Hot signal
Pin 3: Ground at unbalanced end
Pin 3: Ground at unbalanced end
Pin 1: Screen/Ground (not connected
at balanced end if ground loops are
generated)
Pin 2: Hot signal
3
Male XLR
chassis
connector
Female XLR
chassis
connector
DOC02-SQ1SPLITTER_Square ONE Splitter_Op_IssC.pdf 20 27/04/2010 17:00:43