Filter
Top Products
PRECAUTIONS
Phantom power
Never apply phantom power to any unbalanced input
source. Before powering the unit, always check the +48V
status of any phantom powered equipment connected to
any of the 16 output XLRs on the rear panel. If +48V is
detected on any of these outputs the unit will apply +48V
to any devices connected to their corresponding inputs
(front or rear panel) as soon as the unit is powered up.
Radio frequency interference
Class B device
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio TV
technician for help.
Electric fields
Caution:
In accordance with Part 15 of the FCC Rules &
Regulations, “… changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to
operate the equipment.”
Should this product be used in an electromagnetic field
that is amplitude modulated by an audio frequency signal
(20Hz to 20kHz), the signal to noise ratio may be
degraded. Degradation of up to 60dB at a frequency
corresponding to the modulation signal may be
experienced under extreme conditions (3V/m, 90%
modulation).
Operation
Never remove, for example, covers, housings or any other
safety guards.
Never operate the equipment with the covers removed or
if safety guards are ineffective or their effectiveness has
been reduced.
DOC02-SQ1SPLITTER_Square ONE Splitter_Op_IssC.pdf 10 27/04/2010 17:00:42