Filter
Top Products
28
J-300
11.0 Menu Features and Programming Instructions
Your spa is equipped with ve menus that allow you to program
additional features. By continually pressing the Menu button you will
cycle through the menus as follows (Figure 1):
A. Primary Filtration Menu
Allows access to the programming menu for the primary ltration that
uses the circulation pump, page 29. Although the spa has a default
setting this feature is programmable. While in this menu, you can also
program the Change Filter Timer.
B. Secondary Filtration Menu
Allows access to the programming menu for the secondary ltration
that uses Jets Pump 1, page 32. These cycles are used to provide
additional skimming. Although the spa has a default setting this feature is
programmable.
C. CLEARRAY Menu
Allows access to the CLEARRAY® bulb replacement countdown timer,
page 33. Your spa is equipped with the CLEARRAY system that uses
a UV bulb to purify the water. This bulb must be replaced every year.
By programming the countdown timer, a reminder is displayed on the
topside when it is time to replace the bulb. The LED screen will ash
between “blb” and the set temperature. Additionally, the CLEARRAY
indicator light will blink, page 23. The timer needs to be reset in order
to clear the message.
D. Economy Menu
Allows access to the economy programming menu, page 33. The
economy feature has either an “on” or “off” setting where the heater
is allowed to activate for a maximum of 30 minutes at the end of each
secondary ltration cycle.
E. Lock Menu
Activates the locking modes to certain components, features or
operations, page 35.
Current temperature (Main Menu)
Primary Filtration Menu
Secondary Filtration Menu
CLEARRAY/UV Menu
Economy Menu
Lock Menu
Figure 1