Filter
Top Products
34
J-300
CYCLE RUN TIME HEATER RUN TIME
No ltration Maximum of a half hour per day
10 minutes of ltration
every 12 hrs
Maximum of a half hour every 12 hrs
(after secondary cycle ends)
10 minutes of ltration
every 8 hrs
Maximum of a half hour every 8 hrs
(after secondary cycle ends)
10 minutes of ltration
every 6 hrs
Maximum of a half hour every 6 hrs
(after secondary cycle ends)
11.8 Programming the Economy Mode
To activate the Economy Mode, follow the steps below.
A. Press the Menu (
) button four times to display the Economy
Menu (Figure 8). The LED screen will display “ECO.”
B. Press the Warmer ( ) button to enter the menu. The LED screen
will display the current status of the Economy Mode setting, either
ON or OFF.
C. Press the Warmer (
) button to scroll through the settings.
D. Once the new setting appears of the display, press the Jets Pump
1 ( ) button to conrm your selection (Figure 9). The display of
the LED screen will blink twice to indicate that the change has been
accepted. You must press the Jets Pump 1 ( ) button to conrm
your selection or the current settings will remain active.
Note: If no button is pressed within 5 seconds of each selection the
screen will revert back to the Main Menu and the current settings will
remain active.
11.9 Lock Menu
The Lock menu gives you the option to lock specic features of the spa.
There are three locking modes, L1, L2 and L3.
Note: When a lock mode is active, the LED display will ash between the
lock mode and temperature.
L1 lock mode: The jets pumps and heater are deactivated. This mode
can be used when replacing or cleaning the spa lters.
Note: The spa should not be left in this lock mode for an extended period
of time. Especially in colder climate or when freezing conditions exist.
L2 lock mode: The jets pumps, adjust temperature and CLEARRAY
buttons are deactivated. This mode can be used to
prevent unauthorized use of the spa.
PRESS PRESS PRESS
►
◄◄
▲
◄
◄
▼
◄
◄
◄
Figure 8
Figure 9
PRESS
OR