Filter
Top Products
30
J-300
To remove larger debris missed by the primary ltration system, the
control system can activate a secondary ltration system. These cycles
utilize Jets Pump 1 and the second lter cartridge to quickly “skim” the
water of large debris and minimize their “bath-tub ring” effect.
B. For Models J315 and J325
Your new spa includes a 24-hour primary ltration system, which
lters the water continuously (factory default). The circulation pump
draws water through the skimmer bag and one of the two lter cartridges
to effectively remove small debris in your spa. The factory default setting
is PF6. This setting should not be altered. Running the circulation pump
less than the factory recommended time will result in issues with water
quality maintenance.
Note: The 24-hour primary ltration system also supplies heated water to
the spa when the heater turns on.
To remove larger debris missed by the 24-hour primary ltration system,
you can program a secondary ltration system. The secondary ltration
cycles use Jets Pump 1 and the second lter cartridge to quickly “skim”
the water of large debris and minimize their “bath-tub ring” effect.
11.2 Programming the Primary Filtration Cycle
To make changes to the primary ltration cycle, follow the steps below.
A. Press the Menu (
) button once to access the
program settings. The LED screen will display “PF.”
B. Press the Warmer ( ) or Cooler ( ) button to prepare the
system for changes. The LED will display the last cycle programmed
and will blink once to indicate the system is ready to accept changes.
C. Press the Warmer ( ) or Cooler ( ) button to scroll through the
cycles, PF0 to PF8, Figure 2.
D. Once a cycle is selected, press the Jets Pump 1 ( ) button to
conrm the selection. You must press the Jets Pump 1 ( ) button
to conrm your selection or the current settings will remain active.
E. The display will show the new cycle selected and it will blink twice to
indicate that the change has been accepted.
Note: If no button is pressed within 5 seconds of each selection the
screen will revert back to the Main Menu and the current settings will
remain active.
◄ ◄◄
◄
◄
◄
PRESS
PRESS PRESS PRESS
◄ ◄
PRESS PRESS
PRESS
◄
◄
PRESS
PRESS
◄
PRESS
Figure 2