Filter
Top Products
32
J-300
11.4 Secondary Filtration Menu
The jets pump 1 activates during the secondary ltration to provide
additional skimming. The spa is programmed with a default setting of
SF0 but can be programmed to any of the cycle settings listed below,
Figure 5. These cycles schedule the jets pump 1 to run for a preset
amount of time per day, in addition to normal operation.
Note: During the secondary ltration the jets pump 1, circulation pump
and CLEARRAY are activated.
No ltration
10 minutes of ltration every 12 hrs
10 minutes of ltration every 8 hrs
10 minutes of ltration every 6 hrs
11.5 Programming the Secondary Filtration Cycle
To make changes to the Secondary Filter Cycle, follow the steps below.
A. Press the Menu (
) button twice to display the Secondary
Filtration Cycle Menu. The LED screen will display “SF.”
B. Press the Warmer ( ) button to prepare the system for changes.
The LED will display the last cycle programmed and will blink once to
indicate the system is ready to accept changes.
C. Press the Warmer ( ) or Cooler ( ) button to scroll through the
cycles, SF0 to SF3 (Figure 6).
D. Once a cycle is selected, press the Jets Pump 1 ( ) button to
conrm the selection. You must press the Jets Pump 1 ( ) button
to conrm your selection or the current settings will remain active.
E. The display will show the new cycle selected and it will blink twice to
indicate that the change has been accepted.
Note: If no button is pressed within 5 seconds of each selection the
screen will revert back to the Main Menu and the current settings will
remain active.
Figure 5
PRESS
PRESS
PRESS
PRESS
Will return to
“SF” menu
OR
◄
◄
◄
◄
Figure 6