Filter
Top Products
51
6 Installing Other Devices
■ Installing front access bay options
Install a front access bay option such as internal hard disk and CD-ROM drive as follows:
Point
• A SCSI card must be installed before installing an internal SCSI option.
• A SCSI ID must be set for an internal SCSI option to be installed. Refer to the related manual
and set a unique SCSI ID.
• Before installing an internal IDE option, set it to Master, Slave or Cable-Select.
1 Disconnect the power plug from the outlet.
2 Remove the side and upper covers and front panel.
3 Remove the blank panel from the front panel.
Remove two screws from both edges of the blank panel.
The blank panel need not be removed when installing an internal hard disk.
08-DP8 (51-56) 3/2/01, 2:32 PM51