Filter
Top Products
Maintenance
g017617
1
3
2
4
5
Figure 59
1. Rod 4. Deck brackets
2. Spring 5. Spring installed over the
rod
3. Deector assembly
2. Position the new discharge deector assembly
with the bracket ends between the welded
brackets on the deck as shown in Figure 59.
3. Install the spring onto the straight end of the
rod. Position the spring on the rod as shown
in so the shorter spring end is coming from
under the rod before the bend and going over
the rod as it returns from the bend.
4. Lift the loop end of the spring and place
it into the notch on the deector assembly
bracket (
Figure 60).
g017618
1
3
4
2
Figure 60
1. Rod and spring
assembly installed
3. Rod, short end, moved
behind mower bracket
2. Loop end of the spring
installed into the notch in
the deector bracket
4. Short end, retained by
mower bracket.
5. Secure the rod and spring assembly by twisting
it so the short end of the rod can be placed
behind the front bracket welded to the deck
(Figure 60).
Important: The grass deector must be
spring loaded in the down position. Lift
the deector up to test that it snaps to the
full down position.
51