Filter
Top Products
14
Instruction Manual Clarity II T56
PN-51-T56 May 2012
IMPORTANT NOTE:
When using EPA/incandescent sensors (PN 8-0108-0002-EPA):
• DO NOT power up the instrument without the sensor connected
• DO NOT disconnect and reconnect a sensor while an analyzer is powered
If this is inconvenient or cannot be avoided:
1. Cycle power to the instrument after connecting the sensor or...
2. Perform a Slope Calibration or Standard Calibration routine after connecting the
sensor.
Following these guidelines will extend the life of the incandescent lamp and avoid
premature warnings and faults due to reduced lamp life.
F
ig. 3-1 Turbidity signal board with plug-in Sensor connection