Filter
Top Products
Aquatic Fitness System
2005 Owner’s Manual
32
Items Required for Winterizing
• Phillips head screwdriver
• 16” Channel-lock pliers
• High pressure air blower
• Commercial grade wet-vacuum
• 3 to 6 gallons (11.4 to 22.7 liters) of Non-Toxic Antifreeze
• Enough time (and patience) to perform all steps.
Procedure for Winterizing
1. Shut the power off to the system and make sure that it cannot be accidentally turned back
on.
2. Remove filter elements from filter assembly.
3. Drain water from the system using the drain fitting and garden hose or you may use a
submersible pump for faster draining.
4. Open the equipment compartment and locate pumps and heater.
5. Remove all of the drain plugs from each pump.
6. Loosen unions on both sides of each pump, and the heater if applicable.
7. Close all jets, by turning jet faces counter clockwise.
8. Put on your protective goggles in order to protect eyes from air, water, antifreeze or debris
exiting the jets or drains.
9. Insert the hose of a high-pressure air blower into the filter element fitting. Some models
may have 2 filters. Begin with the left-hand filter fitting, which will help evacuate water from
the circulation pump system. Then proceed to the right-hand filter fitting. When using air
blower on single-filter systems or the right-hand fitting on dual filter systems, rotate each of
the jet faces clockwise to open and counter-clockwise to close again. Do this to each jet
face, one jet at a time. Be careful, as water will be coming out of each jet fitting as you
perform this maneuver. Perform this operation, until no more water is coming from the jets.
10. Remove jet faces and insert the hose of a high-pressure air blower into each jet fitting.
Continue this process, until no more water comes out of any jet fitting or drain fitting and you
no longer hear water gurgling within the plumbing. Place all jet faces in a plastic bag and set
aside until you are ready to use your system again.
11.
AquaFit™ DT 19’ Only: Remove bleeder valve from the top of the filter canister area in the
spa area. Place hose of a high-pressure air blower into the bleeder fitting first. Confirm that
water mist is blowing from one or both of the circulation system; return jets in the footwell of
the system. You may also get some water mist blowing from the filter canister. Repeat this
process with the front-most bleeder fitting. Confirm that water mist is blowing from the drain
fittings of the jet pumps.
12. Place the hose of a commercial grade, wet-vacuum over each jet fitting, bleeder valve
fitting, and drain fitting to draw out as much remaining standing water as possible.
13. Remove drain hose bib assembly from the outside bottom of the system.
14. Use the wet-vacuum to remove standing water from the pumps and any other fittings within
the equipment compartment.
15. Read all Directions and Safety Precautions on the Swimming Pool or Recreational Vehicle
antifreeze bottle before opening and using. Ensure that it is non-toxic and safe for this use.
Beware of and follow all safety precautions.