Filter
Top Products
Aquatic Fitness System
2005 Owner’s Manual
20
Spa “Included” –
Dual-Temp Only
Congratulations, AquaFit™Dual Temp Owners! You not only get the pleasures of aquatic exercise in
the “pool side,” you also have a “dedicated spa” on the other side. Take the time to read these
additional instructions carefully because they contain information specific to the spa portion of your
Aquatic Fitness System. If you have any questions, please
contact your local Authorized Dimension
One Spas Dealer.
The spa side is completely “self-contained” from the pool side. This means that the water in the spa
circulates through its own closed system – including pumps and jets. It contains a separate filtration
system and the water chemistry must also be managed separately using the guidelines contained in
the
Water Care
Guide Part No
.
01513-192
.
The following features are included on your spa:
• Meets or exceeds the most stringent requirements of UL1563 Standard for Safety for Electrical
Spas as evaluated and inspected by Edison Test Labs (ETL).
• Completely self-contained with load sharing capabilities
• 100% foam insulated
• Top access, easy to clean filter systems
• Water level referencing weir skimmer
• Proportional FastFlo™ Heater
• A variety of interchangeable jets
• Exclusive, custom hand-set ceramic tile adds a distinctive touch
• Built-in, automatic freeze protection
• Automatic high/low speed filtration cycles
Additional Features
• Programmable Digital control with digital display
• CrystalZone® Water Management System
• Long life, dual speed HydraMax pump
• Dynamic LED Lighting
• 75 sq. ft. (6.97 m
2
) of filtration
Heater and Circulation Pump Control
On all Dimension One Spas, when the water temperature is 1° F (≅0.55° C) below the set
temperature the heater will turn on and remain on until the water temperature rises to 1° F (≅0.55° C)
above the set temperature. To prevent the spa from overheating, the circulation pump turns off
when the water temperature rises 2° F (≅1.1° C) above the set temperature. When the water
temperature cools down to the set temperature, the circulation pump will turn on.
The circulation pump will run for short periods when the water temperature is 2° F
(≅1.1° C) above set temperature to provide optimum operation.
Smart Heat
Smart Heat optimizes heat recovery using the amperage that you have available. Along with
computerized load sharing, that automatically recognizes the number of jet pumps in use,
compares it with the available power, Smart Heat recognizes the difference between the set
temperature and the actual water temperature, and adjusts the heater to optimize the heater
output.