Filter
Top Products
Aquatic Fitness System
2005 Owner’s Manual
14
Tem ase
the
the
incr
on
Temperature Set Buttons
perature Set Buttons: Press the “Warmer” Up Arrow button to incre
desired temperature. Press the “Cooler” Down Arrow button to decrease
temperature. The temperature set point can be adjusted in 1°F (≅0.5°C)
ements from 65°F to 104°F (≅18.3°C to ≅40°C). The new setting will remain
the display for 5 seconds as a confirmation.
This
tem
wa
(e.g
new temperature setting is referred to as the “set
perature” setting throughout this document. It refers to the
ter temperature that you want the system to maintain for you
. 99°F or ≅37.2°C).
Wh
ea
em
In a
also d in
the
en the temperature drops to 2°F (≅1.1°C) below the set temperature, the
ter will turn on until the temperature is 2°F (≅1.1°C) above the set
perature.
h
t
ddition to setting the desired water temperature, these two buttons are
used to change the filter cycles. More information on this is containe
section on “
Programming the Filtration Cycle.”
The
up w s not
yet
Heat Indicator Light, located between the UP and DOWN Arrow Buttons, will light
hile the heater is on and flash when there is a call for heat and the heater ha
been activated.
Jets 1 Button
JETS 1 Button: Press the button once to turn on Pump 1 to Low Speed. A
second press will turn it to High Speed. A third press will typically turn the
pump off, unless the pump has been automatically activated during a heating
cycle – in which case a third press will return the pump to Low Speed. A built-in
timer will automatically shut the pump off after 20 minutes of operation unless
you manually shut if off sooner. The Jets 1 Indicator light will be lit next to the
Jets 1 Button while the pump is running.
Pump 1 provides low or high volume water flow to both the Swim Jets and
HydroTherapy Jets on the AquaFit™ and AquaPro™. The Diverter Valve
controls which set of jets gets the water, and how much is provided. The
AquaFit™ Dual Temp has separate pumps for the Swim Jets and the
HydroTherapy Jets.
Pump 1 also runs on low speed during all filter and heating cycles. If the system is in a
filter cycle, the indicator light for JETS 1 will be on. If you manually press the JETS 1
button, this specific filter cycle will be disabled.