Filter
Top Products
Aquatic Fitness System
2005 Owner’s Manual
30
AquaFit™ and AquaPro™
Always turn off the power to the Aquatic Fitness System before cleaning the filter elements. Refer
to the filter manufacturer’s manual for detailed instructions on removing the filter.
It is recommended that filters be cleaned every month as preventative maintenance. You should
clean the cartridge with a high-pressure garden hose. Every other cleaning, you should also soak
the cartridge in a filter cleaning solution, rinse it thoroughly, and then reinstall it. After cleaning, be
sure to run the pump(s) for a few minutes at high speed, and then return to the heating mode.
Be sure the slice valves and the shut off valve are closed before changing or
cleaning your Aquatic Fitness System filter.
Light Bulb Replacement
All systems are equipped with Dynamic LED Lights. To change the light:
1. Turn the power off and drain the system below the level of
the light.
2. Using the special tool provided in the owner’s manual
packet, unscrew the cover for the light housing.
3. Remove the old light and install the new light.
4. Use the special tool to replace the cover for the light
housing.
5. Check to ensure proper operation of the new light
before refilling the system.
Do not attempt to remove the light housing cover without lowering the water level
below the light housing cover.
Do not attempt to remove the light housing cover without the special tool. If you
are not able to locate it, contact your Dimension One Spas Dealer to have one
sent.
Be sure the O-ring is not damaged and is properly in place when replacing the
lens. Contact your dealer if a replacement O-ring is needed.