Filter
Top Products
OPERATING INSTRUCTION
40
STEP 7
STEP 9
Push the clutch pedal down.
When the engine starts, check the
oil pressure indicators stay on, stop
the engine and find out what is wrong.
NOTE: If the oil pressure indicator stays on after the engine starts,
stop the engine and check the oil level in the crankcase. Add oil if necessary.
Start the engine, if the indicator is still on, do not operate the engine.
Operating the engine without oil pressure will damage engine bearings and
other engine parts. See your dealer.
IMPORTANT:
1. If the engine starts and then stops, wait for the starting motor to stop
turning before you turn the key switch to START position again.
CLUTCH PEDAL
CLUTCH PEDAL
CLUTCH PEDAL
STEP 8
Turn key switch to start position until
engine starts, but no more than
10 seconds, then release the key.
Run engine for two minutes at
1500 RPM.
START
2. Do not use the starter motor for more than 10 seconds without stopping.
Wait one minute between starts so the starter motor can cool.
3. If engine stops when operating with a load, immediately start the engine
again to prevent overheating caused by stopping the flow of oil for cooling
and lubrication.