Filter
Top Products
LUBRICATION/FILTERS/FRUIDS
101
Hydrostatic System Filter (Hydrostatic Drive)
Filter Change Interval Every 200 hours (See NOTE)
NOTE: Change the filter after the first 50 hours of operation and every 200
hours of operation thereafter. Replace the filter more frequently when
operating under unusual dirt and dust conditions. Your Dealer has approved
genuine filters. Do not use other type filters.
When the transmission fluid filter needs changing, change the filter as
follows:
1. Drain the transmission oil. See Transmission Oil Change in this manual.
2. Remove the hydrostatic system filter by turning it counterclockwise.
Use a filter wrench, if necessary.
3. Apply clean oil to the O-ring on the new filter.
4. Install the new filter. Turn the filter clockwise until the O-ring comes in
contact with the filter head surface. Tighten the filter an additional 2/3
turns by hand.
5. Add the transmission oil through the fill port and check the oil level.
6. Run the engine and check for leaks.
7. After stopping the engine, check the oil level. If it is low, add clean oil.
HYDROSTATIC
HYDROSTATIC
SYSTEM
SYSTEM
FILTER
FILTER
HYDROSTATIC
SYSTEM
FILTER
INSTALL
REMOVE