Filter
Top Products
LUBRICATION/FILTERS/FRUIDS
98
TRANSMISSION & HYDRAULIC LUBRICATION
Service Specifications
Oil Level Check Interval Daily
Oil Change Interval Every 200 hours.
Oil Capacity - Gear Drive 28 Liters (29.6 Quarts).
Hydrostatic Drive 31 Liters (32.7 Quarts).
Oil Type - Gear Drive STOU OIL or TOU OIL
Hydrostatic Drive STOU OIL
Hydraulic System Check Yearly inspect for leaks, cracks
and abrasion. Tighten fittings or
replace as needed.
Transmission Oil Level
(Gear Drive)
To check the transmission fluid level,
put the tractor on level ground.
Unscrew the filler cap with dipstick
and wipe it clean. Check level - Do
not screw in cap when checking. If the
fluid level is below the lower line of
the dipstick, add the recommended
fluid to raise the fluid level to the
F (Full) marked position.
Transmission Oil Level
(Hydrostatic Drive)
Before checking the oil level of the
hydrostatic drive tractor, run the engine
for three to five minutes at 1500 RPM
with the speed ratio control lever,
range shift lever and PTO control lever
in Neutral or OFF position. Then check
the oil level in the transmission.
To check the transmission oil level, put the tractor on level ground.
Check the oil level on the transmission dipstick. If the oil level is below the
lower line of the dipstick, add the recommended oil to the transmission to
raise the oil level to the F (Full) marked position.
DIP STICK
DIP STICK