Filter
Top Products
LUBRICATION/FILTERS/FRUIDS
99
Transmission Oil Change
Oil Change Interval Every 200 hours
To change the transmission oil, use
the following procedure:
1. Put the tractor on level ground,
apply the park brake and stop the
engine. Move the range shift lever
to L position.
2. Remove the drain plugs from the
transmission case. (5 )
NOTE: For best results, drain the oil
when the oil is warm.
3. Replace the hydraulic filter. See
Hydraulic Filter in this manual.
4. For the hydrostatic drive tractor,
replace hydrostatic filter, See
Hydrostatic Filter (Hydrostatic Drive)
in this manual.
5. Install the drain plugs with a seal
washer and tighten to a torque of
39 to 44 Nm (29 to 33 lb ft).
6. Add the recommended oil through
the fill hole and check the oil level.
7. Start the engine and check for
leaks.
8. Recheck the oil level after stopping
the engine. If the oil level is low,
add oil up to the specified level.
GEAR DRIVE
HYDROSTATIC DRIVE
FILL HOLE
TRANSMISSION DRAIN PLUG
TRANSMISSION DRAIN PLUG
FILL HOLE