Filter
Top Products
2 3
2 3
PRODUCT SPECIFICATIONS
WARNING
!
To avoid electrical hazards, fire hazards or damage to the tool, use proper circuit
protection.
This tool is wired at the factory for 110-120 Volt operation. It must be connected to
a 110-120 Volt / 15 Ampere time delay fuse or circuit breaker. To avoid shock or fire,
replace power cord immediately if it is worn, cut or damaged in any way.
Before using your tool, it is critical that you read and understand these safety rules.
Failure to follow these rules could result in serious injury to you or damage to the
tool.
MOTOR
Power Source ................................................................. 120V AC, 60Hz, 15 Amp
Arbor Shaft Size ............................................................. 5/8 in.
S
peed ............................................................................. 3800 RPM (No load)
B
rake .............................................................................. Electric
MITER SAW
Miter Detent Stops .......................................................... 0°, 15°, 22.5°, 31.6°, 45° R & L
Bevel Positive Stops ....................................................... 0°, 45° L
Cutting Capacity:
C
rosscut (Maximum Width) ............................................. 3 in. x 7-7/8 in.
C
rosscut (Maximum Height) ............................................ 3-1/2 in. x 5-1/2 in.
45° Miter
Cut R & L .......................................................... 3 in. x 5-1/2 in.
45° Bevel
L ....................................................................... 1-7/8 in. x 7-7/8 in.
45° Miter and 45° Bevel ................................................... 1-1/2 in. x 5-1/2 in.
BLADE
D
iameter ........................................................................... 12 in.
Arbor
Hole ......................................................................... 1 in. dia. w/ 5/8 in. reducer