Filter
Top Products
26 27
26 27
SQUARING THE FENCE (FIG. U)
1. Loosen the four fence locking
bolts (1).
2. Lower the cutting arm and lock in
position.
3. Using a square (2), lay the heel of
the square against the blade and the
ruler against the fence (3) as shown.
4. Adjust the fence 90° to the blade and
tighten the four fence locking bolts.
CAUTION: If the saw has not been
used recently, recheck to make sure
blade is square to the fence and
readjust if needed.
5. After fence has been aligned, using
a scrap piece of wood, make a cut
at 90° then check squareness on the
piece. Readjust if necessary.
Fig. U
MITER ANGLE ADJUSTMENT
(FIG. V, W)
T
he miter saw scale can be easily read
showing miter angles from 0° to 45° to
the left, and right. The most common
angle cut setting slots have positive
stops, permitting fast adjustments to
the desired position. Follow the process
below for quickest and most accurate
adjustments.
1. Lift up on the miter quick lock lever
(1) to unlock the table.
2. Move the turntable while lifting up on
the positive stop locking lever (2) to
align the indicator (3-Fig. U) to the
desired degree measurement.
3. Lock the table into position by
pressing down on the miter quick
lock.
Fig. V
Fig. W
MITER SCALE INDICATOR (FIG. W)
1. Move the table to the 0° positive
stop.
2. Use a screwdriver to loosen the
screw (4) that holds the indicator.
3. Adjust the indicator (3) to the 0°
mark, and retighten.
2
1
3
1
2
1
4
3