Filter
Top Products
26 27
26 27
POSITIVE STOP MITER ANGLE
ADJUSTMENT (FIG. X)
1. Unlock the miter table by lifting up
on the quick-cam miter locking
lever (1).
2. While raising the positive stop
locking lever (2) up, grasp the miter
handle and rotate the miter table left
or right to the desired angle.
3. Release the positive stop locking
lever, and set the miter at the
desired angle, making sure the lever
snaps into place.
NOTE: The lever will only lock into
place at one of the nine positive
stops.
4. Once angle has been obtained,
press down on the quick-cam miter
locking lever (1).
Fig. X
QUICK-CAM MITER TABLE LOCK
OPERATION (FIG. X)
If miter angles required are NOT one
of the nine positive stops noted above,
the miter table can be locked at any
angle between these positive stops by
using the miter quick-cam table lock.
1. Unlock the miter table by lifting up
on the quick-cam miter locking
lever (1).
2. While holding the positive stop
locking lever up, grasp the miter
handle and move the miter table left
or right to the desired angle.
3. Release the positive stop locking
lever (2).
4. Press down on the quick-cam miter
locking lever (1) until it locks the
miter table in place.
NOTE: The quick-cam miter locking
lever should lock the table and
prevent it from moving. If adjustment
is needed, see next step.
QUICK-CAM MITER TABLE LOCK
ADJUSTMENT (FIG. X)
1. Press down and lock the quick-cam
miter table lock.
2. Turn the stop nut (3) to the left, as
shown, using a 1/2 in. wrench to
extend the locking arm against the
base of the miter saw.
3. Test the quick-cam miter table
lock to verify it locks the table into
position securely.
4. Turn the lock nut (4) to the right,
as shown, to lock the miter locking
mechanism into place.
1
2
3
4