Filter
Top Products
T190 Compact Track Loader
93 Operation & Maintenance Manual
HYDRAULIC / HYDROSTATIC SYSTEM (CONT’D)
Removing And Replacing Hydraulic Fluid and Case
Drain Filters
For the correct service interval (See SERVICE
SCHEDULE on Page 67).
Replace the fluid if it becomes contaminated or after
major repair.
Always replace the hydraulic / hydrostatic filter and the
case drain filters whenever the hydraulic fluid is replaced.
(See Removing And Replacing Oil And Filter on
Page 84.)
Open the rear door and raise the rear grill. Remove the fill
cap.
Figure 166
Raise the cab (See Raising on Page 74). Remove the
plug from the top of the reservoir (1) [Figure 166] then
pump the fluid out of the reservoir and into a container.
Recycle or dispose of used fluid in an environmentally
safe manner.
WARNING
Always clean up spilled fuel or oil. Keep heat, flames,
sparks or lighted tobacco away from fuel and oil.
Failure to use care around combustibles can cause
explosion or fire which can result in injury or death.
W-2103-1285
Figure 167
Figure 168
Remove the case drain filters (1) [Figure 167] and
[Figure 168]. Disassemble the filter housings, thoroughly
clean and install new filters. Reassemble and install the
case drain filters. (See Lowering on Page 75.)
Recycle or dispose of used fluid in an environmentally
safe manner.
Add the correct fluid to the reservoir until the fluid level is
at the center of the sight gauge (Do not overfill).
P-24751
1
P-24682
1
Right Side
P-24683
P-24734
1
Left Side