Filter
Top Products
T190 Compact Track Loader
Operation & Maintenance Manual 92
HYDRAULIC / HYDROSTATIC SYSTEM (CONT’D)
Removing And Replacing Hydraulic / Hydrostatic
Filter
For the correct service interval (See SERVICE
SCHEDULE on Page 67).
Open the rear door.
Figure 165
Remove the filter (1) [Figure 165].
Clean the surface of the filter housing where the filter seal
contacts the housing.
Put clean oil on the seal of the new filter element. Install
and hand tighten the filter element.
WARNING
Diesel fuel or hydraulic fluid under pressure can
penetrate skin or eyes, causing serious injury or
death. Fluid leaks under pressure may not be visible.
Use a piece of cardboard or wood to find leaks. Do
not use your bare hand. Wear safety goggles. If fluid
enters skin or eyes, get immediate medical attention
from a physician familiar with this injury.
W-2072-0496
Start the engine and operate the loader hydraulic
controls.
Stop the engine and check for leaks at the filter.
Check the fluid level in the reservoir and add as needed.
WARNING
Always clean up spilled fuel or oil. Keep heat, flames,
sparks or lighted tobacco away from fuel and oil.
Failure to use care around combustibles can cause
explosion or fire which can result in injury or death.
W-2103-1285
P-48470
1