Filter
Top Products
Appendix A
Series AE8
Series AE8 A-1MN2415
Information in this Appendix applies to the AE8 Generator.
Operator Panel Configuration
Figure A-1 AE8 Operator Panel
RUN
MANUAL
OFF REMOTE
AUTO
CONTROLLER
FUSE
Master Control
Switch
Controller
Fuse
Lamp
Circuit Breaker
Master Control Switch − A three position switch allows choice of automatic or manual operating mode.
Run Manual − In this position the controller immediately energizes the crank cycle to start the generator set and produce power.
Off − off position, prevents engine from stating.
Remote Auto − The engine can only be started by making a connection across the remote start terminals of the control box. This allows normal
automatic backup operation of the Generator Set under control of the Transfer Switch.
Controller Fuse − This fuse provides overload protection for the controller circuit board.
Lamp − This Red indicator light will come on when the engine shuts down due to a fault condition.
Circuit Breaker − The 2 pole Circuit Breakers provide overload protection (excessive AC current) for the generator set output windings.