Filter
Top Products
77
Chapter 2: Task Guide
Setting Up Triggers and Running Measurements
the protocol.
On the Internet, there are the following TCP/IP protocols:
• TCP (Transmission Control Protocol), which uses a set of rules to
exchange messages with other Internet points at the information packet
level.
• IP (Internet Protocol), which uses a set of rules to send and receive
messages at the Internet address level.
• HTTP, FTP, SMTP and other protocols, each with defined sets of rules to
use with other Internet points relative to a defined set of capabilities.
To view a picture of the trigger sequence
1. In the Trigger tab, select the Overview subtab.
A picture of the trigger sequence is shown.
See Also “Editing the Trigger Sequence” on page 72
To clear the trigger sequence
1. When the Trigger tab is displayed, select Trigger Sequence or All from the
Clear menu.
Selecting Trigger Sequence restores the default trigger sequence for the
selected sampling mode.
Selecting All restores the default trigger sequence, trigger settings, and
default storing if in the state sampling mode.
To restore default trigger settings
1. When the Trigger tab is displayed, select Settings from the Clear menu.
Settings (acquisition depth and trigger position) are returned to their
defaults. In the state sampling mode, time tags are turned back on. In the
timing sampling mode, the sample period returns to its fastest setting.