Filter
Top Products
34
Chapter 2: Task Guide
Probing the Device Under Test
Adapter-to-Board
Connection
Both the 01650-63203 and the E5346A adapters include termination
for the logic analyzer. The 01650-63203 termination adapter plugs into
a 2 x 10 pin header with 0.1 inch spacing. The E5346A high-density
adapter connects to an AMP "Mictor 38" connector. If possible, use
support shrouds around the Mictor connector to relieve strain and
improve connections.
Direct Pod-to-Board
Connection
If you provide proper termination as part of the device under test
board, you can plug the pod directly into the ©3M 2520-series, or
similar alternative connector. Suggested termination is shown in the
Logic Analysis System and Measurement Modules Installation
Guide.
Also use this termination with the Agilent Technologies E5351A high-
density, non-terminated adapter.
Pod-to-Analysis
Probe Connection
Analysis probes (formerly called preprocessors) are microprocessor-
specific interfaces that make it easier to probe buses. Generally,
analysis probes consist of a circuit board that attaches to the
microprocessor (possibly through an adapter) and a configuration file.
The configuration file sets up the logic analyzer's clocks and labels