Filter
Top Products
170
Chapter 3: Reference
Error Messages
Error Messages
• “Analyzer armed from another module contains no "Arm in from IMB"
event” on page 185
• “Branch expression is too complex” on page 171
• “Cannot specify range on label with clock bits that span pod pairs” on
page 176
• “Counter value checked as an event, but no increment action specified” on
page 177
• “Goto action specifies an undefined level” on page 177
• “Hardware Initialization Failed” on page 178
• “Maximum of 32 Channels Per Label” on page 177
• “Must assign another pod pair to specify actions for flags” on page 178
• “Must assign Pod 1 on the master card to specify actions for flags” on
page 171
• “No more Edge/Glitch resources available for this pod pair” on page 178
• “No more Pattern resources available for this pod pair” on page 179
• “No Trigger action found in the trace specification” on page 179
• “Slow or Missing Clock” on page 180
• “Timer value checked as an event, but no start action specified” on
page 180
• “Trigger function initialization failure” on page 181
• “Trigger inhibited during timing prestore” on page 182
• “Trigger Specification is too complex” on page 182
• “Waiting for Trigger” on page 184