Sanyo PLC-XU305A Manual

A SERVICE OF

next previous

66

Problem: –Solutions

 –PlugthepowercordoftheprojectorintotheACoutlet.

  –SeeifthePOWERindicatorlightsred.

  –WaituntilthePOWERindicatorstopsblinkingtoturnontheprojector

again.TheprojectorcanbeturnedonafterthePOWERindicator

turnsred.Seepage20.

  –ChecktheWARNINGindicator.IftheWARNINGindicatorlightsred,

projectorcannotbeturnedon.Seepage61.

  –Checktheprojectionlamp.Seepage64.



  –UnlocktheKeylockfunctionfortheprojector.Seepage56.

–MakesureOff orCountdown offarenotchosenatdisplay 

function.Seepage48.

–MakesureUserorOffarenotchosenatLogo(select)

function.Seepage49.

–MakesureInputsearchfunctionisadjustedproperly.Seepage47.

–ThatistheFilterwarningicon.Seepage58.

–ThatistheLampreplacementiconortheFilterwarningicon.See

pages58,64.

 –Adjustfocusoftheprojector.Seepage25.

  –Provideproperdistancebetweentheprojectorandtheprojection

   screen.Seepage15.

  –Checktheprojectionlenstoseeifitneedscleaning.Seepage63.

  –Movingtheprojectorfromacooltowarmplacemayresultin 

   moisturecondensationontheprojectionlens.Insuchcases,leave

   theprojectoroffandwaituntilcondensationevaporates.

 –ChecktheCeiling/Rearfunction.Seepage52.

 –ChecktheCeilingfunction.Seepage52.



–CheckiftheContrastorBrightness areadjustedproperly.See

   pages36,43.

  –Checkif Image modeisselectedproperly.Seepages35,42.

  –Checkthelampcontrolfunction.Seepages27,55.

  –ChecktheLAMPREPLACEindicator.Ifitlights,theendoflamplife

   isapproaching.Replacethelampwithanewonepromptly.Seepage

   64.

Appendix

Troubleshooting

Beforecallingyourdealerorservicecenterforassistance,checktheitemsbelowonceagain.

–Makesureyouhaveproperlyconnectedtheprojectortoperipheralequipmentasdescribedonpages16-18.

–MakesureallequipmentisconnectedtoACoutletandthepoweristurnedon.

–Whentheprojectordoesnotprojectanimagefromtheconnectedcomputer,restartthecomputer.

No power

The initial display is not shown.

The initial display is not same

as the default set.

Input signal switches automatically.

(or does not switch automatically)

When the projector is on and

youpress the input button, an icon

other than the Lamp mode icon

appears.

An icon other than Input mode or

Lamp mode icon appears.

Image is out of focus.

Image is Left/Right reversed.

Image is Top/Bottom reversed.

Picture is not bright enough.

Appendix