A SERVICE OF

logo

Open as PDF
next previous
55
Remote control
Thisfunctionallowsyoutochangebrightnessofthe
screen.
Normal......Normalbrightness
Eco............ Lowerbrightnessreducesthelamp
powerconsumptionandextendsthe
lamplife.
Lamp control
Remote control
Lamp life control
Theeight different remotecontrol codes(Code 1–Code8)
are assigned to the projector; the factory-set, initialcode
(Code1)andtheothersevencodes(Code2toCode8).
Thesame codeshould set onboththe projectorand the
remote control. For example, operating the projector in
Code 7,theremotecontrolcodealsomustbeswitchedto
Code 7.
To change the code for the projector
SelectaremotecontrolcodeinthisSettingMenu.
To change the code for the remote control:
While holding down the MENU button,press the IMAGE
buttonthe number oftimes correspondingtotheremote
controlcodefortheprojector.See“Remote Control Code”
onpage13.
Lamp control
Selectthelampoperationwhenthetotallightingtimeofa
lampexceedstherecommendedtotalhoursofuse.
Mode 1..............Thelampcanbeturnedonevenafter
exceedingtherecommendedtotal
hoursofuse.
Mode 2..............Thelampcanbeturnedonevenafter
exceedingtherecommendedtotal
hoursofuse.Buttheprojectorturnsoff
automaticallyafter3minutes.
Lamp life control
Setting
Note:
•Lampmodecannotbechangedforawhileafterturning
ontheprojector.Lampneedssometimetostabilizeafter
thepoweristurnedon.Storedlampmodewillbeactive
afterthelampisstabilized.
•IfMode 2hasbeenselectedandtheprojectionlamp
exceedstherecommendedtotalhoursofuse,the
replacementiconwillbedisplayedatthetimeofpower-
on.Thentheprojectorwillturnoffafter3minutes.
•TheLampreplacementiconwillnotappearwhenthe
DisplayfunctionissettoOff(p.48),during"Freeze"(p.27),
or"Noshow"(p.28).
Note:
•Whendifferentcodesaresetontheprojectorandontheremotecontrol,anyoperationcannotbemade.In
thatcase,switchthecodeontheremotecontroltofitthecodeontheprojector.
•Ifthebatteriesareremovedfromtheremotecontrolforalongperiodoftime,theremotecontrolcodewill
bereset.
Lamp replacement icon