Sanyo PLC-XU305A Manual

A SERVICE OF

next previous

51

Setting

Enter a Logo PIN code

UsethePoint▲▼buttonstoenteranumber.Pressthe

Point►buttontofixthenumberandmovetheredframe

pointerto the next box.The number changes to .If

youfixedanincorrectnumber,usethePoint◄buttonto

movethepointertothenumberyouwanttocorrect,and

thenenterthecorrectnumber.

Repeatthissteptocompleteenteringafour-digit

number.

Afterenteringthefour-digitnumber,movethepointerto

Set.PresstheSELECTbuttonsothatyoucanstartto

operatetheprojector.

If youenteredan incorrect LogoPIN code, Logo PIN

code and the number ( ) will turn red for a

moment.EnterthecorrectLogoPINcodealloveragain.

LogoPINcodecanbechangedtoyourdesiredfour-digit

number.Pressthe Point ▼ buttontoselect Logo PIN

code changeandthenpresstheSELECTbutton.The

NewLogoPINcodeinputdialogboxappears.Setanew

LogoPINcode.

BesuretonotethenewLogoPINcodeandkeepiton

hand.Ifyoulostthenumber,youcouldnolongerchange

the Logo PIN code setting. For details on PINcode

setting,referto"PINcodelock"onpages56-57.

UsethePoint▲▼buttonstoswitchOn or Off,andthen

presstheSELECTbuttontoclosethedialogbox.

Change the Logo PIN code lock setting

Enter a Logo PIN code

AfteracorrectLogoPINcode

isentered,thefollowingdialog

boxappears.

CAUTION:

WHEN YOU HAVE CHANGED THE LOGO PIN

CODE, WRITE DOWN THE NEW PIN CODE

IN COLUMN OF THE LOGO PIN CODE NO.

MEMO ON PAGE 79, AND KEEP IT SECURELY.

SHOULD THE LOGO PIN CODE BE LOST OR

FORGOTTEN, THE LOGO PIN CODE SETTING

CAN NO LONGER BE CHANGED.

Change the Logo PIN code lock setting

Change the Logo PIN code

Logo PIN code change