MX3X with Label
MX3X with Label
If the MX3X has a Bluetooth address barcode label attached, follow these steps:
1. Scan the Bluetooth address barcode label, attached to the MX3X, with the LXE Bluetooth mobile scanner.
2. If this is the first time the Bluetooth scanner has scanned the MX3X Bluetooth label, the devices are paired. See section
titled “Bluetooth Beep and LED Indications”. If the devices do not pair successfully, go to the next step.
3. Open the LXEZ Pairing panel [Start | Settings | Control Panel | Bluetooth].
4. Tap Discover. Locate the Bluetooth scanner in the Discovery panel.
5. Double-tap the stylus on the Bluetooth scanner. The right-mouse-click menu appears.
6. Select Pair as Scanner to pair the MX3X with the Bluetooth mobile scanner.
The devices are paired. The Bluetooth barcode reader responds with a series of beeps and an LED flashes. Refer to the
following section titled “Bluetooth Beep and LED Indications”.
Note: After scanning the MX3X Bluetooth label, if there is no beep and no LED flash from the Bluetooth device, the
devices are currently paired.
E-EQ-MX3XRG-W-ARC [ 86 ] MX3X Reference Guide
