Available PostScript Memory
This option specifies the amount of available PS memory and provides a spin box for changing this
value. The available PS memory is a subset of the printer's total physical memory. The default PS
memory setting for the HP Color LaserJet 2820/2830/2840 all-in-one is 2048 KB. It is usually best to
set the PS memory to match what is shown on the configuration page. To print a configuration page
from the HP Color LaserJet 2820/2830/2840 all-in-one control panel, follow these steps:
1 At the product control panel, press M
ENU
.
2 Press the < or > button to scroll to Reports and press E
NTER
.
3 Press the < or > button to scroll to Config Report and press E
NTER
.
Output Protocol
This option specifies the protocol that the HP Color LaserJet 2820/2830/2840 all-in-one uses for print
jobs. The following options are available.
■ ASCII (default)
■ TBCP
■ Binary
When you click ASCII, data is sent in ASCII format (7-bit), which might take longer to print but can be
sent through any I/O channel, such as a USB or network port.
When you click TBCP (Tagged Binary Communications Protocol), all data except special control
characters is sent in binary (8-bit) format. The binary formats can be sent over USB or serial
communications ports at a faster rate than by sending data in ASCII format.
When you click Binary, all data except special control characters is sent in binary (8-bit) format. The
binary formats can be sent over USB communications ports at a faster rate than by sending data in
ASCII format.
Send CTRL-D Before Each Job
This option specifies whether the HP Color LaserJet 2820/2830/2840 all-in-one will be reset at the
beginning of every .PS document. The default setting is No. Ctrl-D resets the printer to its default setting
to ensure that previous print jobs do not affect the current print job. Ctrl-D might cause a print job to fail
if the printer is connected through a network. If your document fails to print when sent to a printer
connected through a USB port, change No to Yes.
Send CTRL-D After Each Job
This option specifies whether the HP Color LaserJet 2820/2830/2840 all-in-one will be reset at the end
of every .PS document. The default setting is Yes. Ctrl-D resets the printer to its default setting to ensure
that future print jobs are not affected by the current print job. Ctrl-D might cause a print job to fail if the
printer is connected through a network. If your document fails to print when sent to a network printer,
change Yes to No.
Convert Gray Text to PostScript Gray
This option specifies whether to convert the true gray (RGB value) in text to the gray that the
PS Emulation Unidriver provides. The default setting is No.
ENWW
HP PCL 6 and PS emulation unidriver features (for Windows 2000 and Windows XP)
95
Windows HP unidriver
features
