Filter
Top Products
EFFECT EDIT MODE
93
NOTES
●
Even though the System routing applies the selected effect to all Parts, you can control how much the Reverb, Chorus and Variat
ion effects are applied to any indi-
vidual Part (with the
Reverb Send, Chorus SendReverb Send, Chorus Send
Reverb Send, Chorus SendReverb Send, Chorus Send
Reverb Send, Chorus Send and
Variation SendVariation Send
Variation SendVariation Send
Variation Send parameters in the Single Part controls; see pages 38, 39). For the effects to be properly heard, the
Reverb Return, Chorus ReturnReverb Return, Chorus Return
Reverb Return, Chorus ReturnReverb Return, Chorus Return
Reverb Return, Chorus Return and
Variation ReturnVariation Return
Variation ReturnVariation Return
Variation Return parameters in the All Parts controls must also be set to appropriate values (see pages 41, 42).
●
The stereo position of the effects is controlled by the
Reverb Pan, Chorus PanReverb Pan, Chorus Pan
Reverb Pan, Chorus PanReverb Pan, Chorus Pan
Reverb Pan, Chorus Pan and
Variation Pan Variation Pan
Variation Pan Variation Pan
Variation Pan parameters; see pages 87, 88, 91.
●
You can set Reverb, Chorus and Variation to be routed in parallel or in serial, and you can determine the amount of Variation e
ffect that is sent to Chorus and Reverb,
as well as the amount of Chorus that is sent to Reverb. This is done with the
Send Variation to ChorusSend Variation to Chorus
Send Variation to ChorusSend Variation to Chorus
Send Variation to Chorus (page 91),
Send Variation to ReverbSend Variation to Reverb
Send Variation to ReverbSend Variation to Reverb
Send Variation to Reverb (page 91), and
Send ChorusSend Chorus
Send ChorusSend Chorus
Send Chorus
to Reverbto Reverb
to Reverbto Reverb
to Reverb (page 89) parameters. When these are all set to
00
00
0, all three effects are in parallel routing. Higher values for each provide varying degrees of serial routing.
When Variation is set to System:
Variation
Return
Variation
Pan
Volume Expression
Volume Expression
Volume Expression
Rev Send
Cho Send
Var Send
Dry Level
Volume Expression
Pan
Part 1
REVERB
Reverb Return
Chorus Return
Send Chorus to Reverb
Send Variation to Chorus
Send Variation to Reverb
DRY LINE
PAN
PAN
PAN
Reverb Pan
Chorus Pan
OUTPUT
Thick line indicates stereo signal.
VARIATION CONNECTION = SYSTEM
CHORUS
VARIATION
SYSTEM EFFECT
Rev Send
Cho Send
Var Send
Dry Level
Pan
Part 2
Rev Send
Cho Send
Var Send
Dry Level
Pan
Part 3
Rev Send
Cho Send
Var Send
Dry Level
Pan
Part 16