Filter
Top Products
Installation
36 975-0126-02-01
Step 8: Performing Checks Prior to Initial Start-Up
Before testing your installation, ensure these conditions are met:
❐ Chassis and AC grounds are properly installed.
❐ AC input connections and AC output connections are wired correctly on the
terminal block and not reversed.
❐ Positive (+) battery cable is connected to the house bank positive (+) battery
terminal through the DC fuse and disconnect switch or DC circuit breaker.
❐ Negative (–) battery cable is connected to the house bank negative (–) battery
terminal.
❐ House battery voltage is within the proper range for this unit
(10.3–15.3 volts DC).
❐ DC disconnect switch or breaker is turned off.
❐ Echo Charger disconnect switch is off or fuse is removed.
❐ Echo Charger connections are correct: positive (+) cable runs from the Echo
Charger to the positive terminal of the engine battery.
❐ Both the house battery and the engine battery negative terminals are
connected to the engine negative terminal/bus.
❐ AC input and output breakers are turned off.
❐ All connections are tight.