Filter
Top Products
Installation
975-0126-02-01 35
Step 7: Connecting to the Network
For your reference, Figure 17 shows where the network connections are made on
the MS2000. The network cable can be plugged into either one of the two network
jacks on the MS2000.
Detailed information on planning and installing your network is available in the
Xanbus System Installation Guide. Refer to the this guide to determine the type of
network layout to install, as well as guidelines for installing the network.
The Xanbus System Installation Guide is available for download at
www.xantrex.com
CAUTION: Equipment Damage
Connect the MS2000 only to other Xanbus compatible devices.
Although the cabling and connectors used in this network system are the same as Ethernet
connectors, this network is not an Ethernet system. Equipment damage may result from
attempting to connect two different systems.
Figure 17
Connecting to a Network Jack