Filter
Top Products
Installation
975-0126-02-01 13
Unpacking and Inspecting the Inverter/Charger
Materials List
Contents The following materials are in the shipping box:
• MS2000 Sine Wave Inverter/Charger
• DC terminal covers (one red, one black) and four screws
• Bag containing DC terminal hardware:
• Two flat washers
• Two lock washers
• Two 3/8" bolts
• Battery temperature sensor
• MS2000 Sine Wave Inverter/Charger Installation Guide
• MS2000 Sine Wave Inverter/Charger Operation Guide
To unpack and inspect:
1. Unpack the unit and check the materials list. If anything is missing from the
shipping box, contact Xantrex Customer Service. See “Contact Information”
on page iii.
2. Record the serial number of the MS2000 and other purchase information in
the “Warranty and Product Information” section of the MS2000 Sine Wave
Inverter/Charger Operation Guide. You will be asked for this product
information if you need to call Xantrex Customer Service.
WARNING: Heavy load
The MS2000 Sine Wave Inverter/Charger weighs approximately 67 lbs (30 kg). The unit
is too heavy for one person to safely lift and mount. Xantrex recommends that two people
lift and mount the unit. Always use proper lifting techniques during installation to prevent
personal injury.
Figure 3
MS2000 Hardware Materials as Shipped