Filter
Top Products
Installation
975-0126-02-01 17
Close to
battery
compartment
The length and size of your DC cables will affect
performance. Use the DC cables recommended in Table 2
on page 12. The unit should not be installed in the battery
compartment due to the possible presence of explosive
hydrogen gas from the batteries.
Protected
from battery
acid and gases
Never place the inverter/charger directly above the
batteries—gases from battery will corrode and damage the
inverter/charger. Never allow battery acid to drip on the
inverter/charger or its wiring when filling the batteries or
reading their specific gravity.
Orientation To meet regulatory requirements, the MS2000 must be
mounted in an approved mounting orientation. See Figure 4
on page 19. These orientation restrictions are designed to
stop dripping water, due to condensation in damp marine
environments, from getting inside the MS2000.