Filter
Top Products
Installation
30 975-0126-02-01
3. Using the slot screwdriver with a 1/8" blade, press down on the tension clip
through the slot located at the top of the connector. While pressing down on
the tension clip, insert the end of the cable with insulation removed into the
left-side round hole at the front of the connector. See Figure 12.
OR
You can also insert the screwdriver blade into the square hole above the left-
side hole and twist the screwdriver to press down on the tension clip before
inserting the cable.
4. To secure the cable, remove the screwdriver to release the tension clip.
5. Install the disconnect and 15 A DC over-current protection between the other
end of the cable and the battery positive (+) terminal, as close as possible to
the battery in accordance with codes.
6. Open the disconnect switch or remove the fuse.
Important:
The right-side hole on the Echo Charger connector does not connect to
anything internally and should not be used. If you connect the Echo Charger to the engine
battery using the right-side connector, the Echo Charger will not work.
Figure 12
Inserting Cable into the Echo Charger Connector
To MS2000
Echo Charger port.
Insert screwdriver into left-side
top notch or front notch.