Filter
Top Products
6 Mount Installation
MAN0041 (Rev. 4/4/2008)
Torque Hardware
Torque all hardware to specifications listed below.
NOTICE
■ Check torque value of mount hardware after
10 hours of operation and again after every 50
hours of operation.
Install Weather Cap on Exhaust Pipe
NOTE: After the hydraulics and loader are install on
the tractor, check the clearance between the top of
the exhaust pipe and the loader boom when the
loader is raised. If there is interference, a weather cap
will need to be installed.
1. Remove exhaust pipe from the tractor. Save
hardware for later use.
2. Remove approximately 6-inches from the top of
the exhaust pipe.
3. Attach exhaust pipe to the tractor. Make sure that
the support flange on the exhaust pipe is between
the tractor and the support bracket as shown in
page 6. Secure using hardware previously
removed.
4. Attach weather cap to the top of the exhaust pipe
with supplied hardware. Position cap hinge to the
rear. See Figure 5. Weather cap is included in the
loader mount kit.
Figure 4. Exhaust Pipe Reinstalled
Figure 5. Weather Cap Installed
TORQUE SPECIFICATIONS
Ref. Cap Screw Qty Wrench
Size
Required Torque
7 M20 x 2.5P x 40 mm 2 30 mm 244 lbs-ft. (330 N-m)
5 M20 x 2.5P x 50 mm 8 30 mm 244 lbs-ft. (330 N-m)
8 M20 x 2.5P x 70 mm 4 30 mm 244 lbs-ft. (330 N-m)
DP7
Forward
DP8