Filter
Top Products
12 Hydraulic Installation
MAN0041 (Rev. 4/4/2008)
46945 Hose Kit
Attach Hoses to Control Valve
NOTICE
■ If hydraulic lines are not connected as shown
in the mount installation manual or tractor man-
ual, the loader control valve may be damaged. A
blocked outlet (RETURN) or improper hose con-
nection will cause pressurized oil to enter the
return circuit and damage the valve or the tractor
hydraulic system.
1. Attach 90° end of hoses (2) to the IN, OUT, and
PBY ports on the control valve.
2. Route hoses over hose guide (as shown in Figure
15), under right side of platform, and over right
rear axle.
2. 46947 Hose, 120” x 3/4 JICF x 7/8 JICF
Figure 16. Control Valve Hose Connections
Install Hydraulic Fittings and Hoses
1. Locate the hydraulic ports on the rear of the trac-
tor as shown in Figure 17.
2. Remove tube and fittings from the PBY,
PRESSURE, and RETURN ports.
Figure 17. Tractor Hydraulic Connections
PRESSURE
PBY
RETURN
DP3