26 Hydraulic Installation
MAN0041 (Rev. 4/4/2008)
1023583 Hose Kit
Install Hose Hanger
1. Remove lower bolt, washers, and nut that
secures right fender to the ROPS.
2. Keep larger washer and discard the remaining
hardware.
3. Attach hose hanger (9), using spacer (10), cap
screw (12), flat washer (from tractor), lock washer
(13), and nut (14) as shown in Figure 48 and
Figure 49.
4. Route PRESSURE and PBY hoses through
hanger as shown in Figure 49.
5. Secure hoses into position using lock pin (11).
6. Tighten all hydraulic fittings securely.
9. 58280 Hose hanger
10. 46948 Spacer
11. 58047 Lock pin
12. 31138 3/8 NC x 3-1/2 HHCS
13. 838 3/8 Lock washer
14. 835 3/8 NC Hex nut
Figure 48. Hose Hanger Installation
Figure 49. Hose Hanger Installed
Connect Work Port Hoses
1. The control valve kit contains hoses assembled
with quick couplers. Attach supply hoses to
loader feedlines, following the color scheme
shown in Figure 50.
2. Connect loader supply hoses to control valve
hydraulic couplers when attaching loader.
Figure 50. LU126 & LU132 Control Valve and Loader Feedline Hose Connections
