Filter
Top Products
24 Hydraulic Installation
MAN0041 (Rev. 4/4/2008)
1023583 HOSE KIT
General Description
These set up instructions are for operating the LU126
or LU132 loader using single lever control valve
mounted to the right loader mount as shown in Figure
43. To use this hydraulic connection the hoses must
be connected between the control valve and the trac-
tor hydraulic system located at the rear of the tractor.
NOTE: After the hydraulics and loader are install on
the tractor, check the clearance between the top of
the exhaust pipe and the loader boom when the
loader is raised. If there is interference, a weather cap
will need to be installed. See Page 6 for installation
instructions.
NOTICE
■ If hydraulic lines are not connected as shown
in this manual, the control valve may be damaged.
A blocked outlet (RETURN) or improper hose con-
nection will cause pressurized oil to enter the
return circuit and damage the valve.
Figure 43. Control Valve Installed (Typical)
Install Hydraulic Fittings to Control Valve
1. Remove open-center plug from the side of the
control valve.
2. Install PBY conversion plug (18) and elbow (17),
supplied with hose kit, into the side of the control
valve.
3. Attach elbow (5) to the fitting in the IN port of the
control valve.
5. 313032 Elbow, 3/4 JICM x 3/4 JICF 90°
17. 60 Elbow, 3/4 JICM x 7/8 ORBM
18. 346143 Power-Beyond conversion plug
Figure 44. Cable Control Valve Fitting Installation
DP10