Filter
Top Products
10 Hydraulic Installation
MAN0041 (Rev. 4/4/2008)
58025 Hose Kit
Verify Control Movements
1. Mount loader to tractor: Remove mount pins
from loader uprights. Align tractor with loader and
slowly drive tractor into loader. Shut off tractor.
2. Connect loader feedline hoses to tractor remote
control couplers. See Figure 9.
3. Comply with all safety rules and start the tractor.
4. Mount loader to tractor by activating bucket
cylinders to raise or lower the loader uprights into
the loader mounts. Slowly advance tractor
forward, activating appropriate cylinders to
engage loader completely into mounts. Insert
mounting pins to secure loader.
5. Check that all hydraulic control lever positions
operate the loader movements correctly as
shown in Figure 12.
6. If loader movements do not respond correctly,
shut off tractor, relieve pressure, and reconnect
properly. Loader control movements must be
correct before proceeding.
7. Once all loader functions are correct, start the
tractor and operate the loader to check for leaks.
Purge any remaining air from the hydraulic
system and check oil level.
8. When hose routings and correct loader
operations are verified, identify each circuit by
placing a matching colored band around the male
and female quick couplers. The color-coded
bands will make reinstallation easier when the
loader is removed from tractor.
9. Be sure that adequate slack is left in the hoses so
they can move as the loader moves through its
full range of motion.
10. Attach the plastic tie straps (included in kit) every
20-inches around the hoses to keep them tightly
bundled and away from contact with the ground
or other moving parts on the tractor or loader.
11. Before operating the loader, make sure that the
Pre-Delivery, Delivery, and Pre-Operation
Checklists from the Operator section in the
Loader Operator’s Manual have been completed.
Figure 12. Tractor Hydraulic Control Levers
CM1570
Control 2
Control 1
DP1
● Control 1, Handle forward - Boom down
● Control 1, Handle back - Boom up
● Control 2, Handle forward - Dump bucket
or attachment
● Control 2, Handle back - Rollback bucket
or attachment