Filter
Top Products
Hydraulic Installation 23
MAN0041 (Rev. 4/4/2008)
1023584 Hose Kit
Install Hose Hanger
1. Remove a bolt from the bottom of right
cab/operator’s platform support.
2. Attach hose hanger (4) and secure with tractor
hardware previously removed.
3. Place hoses in hose hanger when routing
hydraulic hoses to the tractor hydraulic couplers.
4. Secure hoses in position using lock pin (5).
4. 59520 Hose hanger
5. 58047 1/4 x 2-1/2 Lock pin
* Tractor hardware
Figure 41. Hose Hanger Installation
Verify Control Movements
1. Mount loader to tractor: Remove mount pins
from loader uprights. Align tractor with loader and
slowly drive tractor into loader. Shut off tractor.
2. Connect loader feedline hoses to tractor remote
control couplers. See Figure 42.
3. Comply with all safety rules and start the tractor.
4. Mount loader to tractor by activating bucket
cylinders to raise or lower the loader uprights into
the loader mounts. Slowly advance tractor
forward, activating appropriate cylinders to
engage loader completely into mounts. Insert
mounting pins to secure loader.
5. Check that all tractor hydraulic control lever
positions operate the loader movements correctly.
6. If loader movements do not respond correctly,
shut off tractor, relieve pressure, and reconnect
properly. Loader control movements must be
correct before proceeding.
7. Once all loader functions are correct, start the
tractor and operate the loader to check for leaks.
Purge any remaining air from the hydraulic
system and check oil level.
8. When hose routings and correct loader
operations are verified, identify each circuit by
placing a matching colored band around the male
and female quick-disconnect coupler. The color-
coded bands will make reinstallation easier when
the loader is removed from the tractor.
9. Be sure that adequate slack is left in the hoses so
they can move as the loader moves through its
full range of motion.
10. Attach the plastic tie straps (included in kit) every
20-inches around the hoses to keep them tightly
bundled and away from contact with the ground
or other moving parts on the tractor or loader.
11. Before operating the loader, make sure that the
Pre-Delivery, Delivery, and Pre-Operation Check
Lists in the Loader Operator’s Manual have been
completed.
Figure 42. Loader Feedline to Tractor Remote Coupler Connections