Filter
Top Products
Page 43
D. Open/Close Front Panel
Place thumb on front panel release button (7) with forefinger below front
overhang. Press firmly on release button, then flip panel open by pulling out-
ward at top edge. To close panel, flip panel up and press firmly until you
hear an audible click. Keep the front panel closed at all times to prevent
water intrusion, except when changing discs. CAUTION: never insert wet
discs into unit or CD player will be damaged!
E. Radio Operation
Press source button (4) to select radio mode. Station frequency is
indicated on display.
•To Select Band: press band button (12) to toggle through radio modes
as follows: FM1 - FM2 - FM3 - AM1 - AM2 - FM1. Each radio band
stores up to 6 independent presets, for a total of 18 FM and 12 AM
presets.
•To Program Presets: tune in desired radio station, then press and hold
desired preset button for at least 2 seconds. PX”, where X=preset num-
ber, appears at bottom right of the display. Note: When power to spa
is shut off for any reason, all station presets are reset.
F. Automatically Setting Station Presets
To automatically set station presets to their next higher stations, press the
preset button (1 to 6) from which to start programming, then press and
hold the auto button (16) for at least 2 seconds. The current station
preset and additional preset memories up to P6 will be reprogrammed
with their next higher tunable stations. When the auto preset cycle is
complete, the unit will remain in preset scan mode and continue scanning
for presets until the auto button (16) is pressed. To select only the
strongest stations, press the local button (10). All 18 FM and 12 AM
presets can be set sequentially by selecting the next band and continuing
the operation during auto programming.
G. Seek / Manual Tune
Press tune/seek-up button (13) once to automatically tune the next higher
station. Press tune/seek-down button (14) once to automatically tune the
next lower station. To manually tune to a specific station frequency, press
and hold either tune/seek button for at least 2 seconds. Holding either
button down will increase or decrease the displayed frequency manually.
When the desired frequency is reached, release the button. The unit
remains in manual tune mode for 3 seconds after either button is released
so you can fine tune the station frequency with additional button presses.
Note: After 3 seconds, seek mode is re-enabled.