Filter
Top Products
** In 30A configuration, the heater will not operate while either pump is
running in high speed or when the air blower is running. Note: pump #2
runs only in high speed.
*** In 60A configuration, the heater will operate while both pumps are
running in high speed and the blower is running. Note: Not applicable for
1-pump Capri models.
7.0 Start-Up Instructions
FOR BEST RESULTS, READ EACH STEP IN ITS ENTIRETY BEFORE
PROCEEDING WITH THAT STEP.
A. Prepare Hot Tub for Filling
• Clear all debris from the hot tub. (Although the hot tub shell has been
polished at the factory, you may want to treat it with a specially
formulated hot tub cleaner. Consult your dealer for additional
information prior to filling spa.
• Remove the filter lid (Figure-F, page 17), then remove filter cartridge as
illustrated in section 11.1, page 28-29.
B. Fill Hot Tub
• Place the end of your garden hose into the empty filter bucket.
NOTE: Never fill with water from a water softener. If your water is extreme-
ly “hard”, it is preferable to fill half-way with hard water and the rest of the
way with softened water. Or, you may fill entirely with hard water if you use
a special water additive available from your Sundance dealer.
• Fill the hot tub until the water level is midway in the filter bucket
skimmer opening and above all jets. Do not overfill.
Important: Always fill your hot tub through the filter bucket after draining.
Failure to do so may cause air to be trapped in either pump, preventing
the pump from circulating water.
Page 13