Filter
Top Products
Page 26
10.3 Programming The Change Filter Reminder
Your new spa is equipped with a programmable “Change
Filter” reminder that appears on the control panel display after
a specified number of days. It is designed to remind you to clean and/or
replace your filter cartridge(s) on a regular basis but does not affect spa
operation in any way. This reminder must be reset at each filter cleaning
interval. It offers a selectable range from 10-120 days or can be disabled.
We recommend an initial setting of 30 da
ys, after which you can easily
determine whether you need to shorten or lengthen its interval by visually
inspecting your filter cartridge. Refer to section 11.1 (page 28) for filter
cleaning recommendations.
Programming Instructions
(1) Press the CYCLE sensor six times
. The main display reads “FIL”
indicating the “Change Filter” display program has been accessed.
(2) Press SELECT sensor once to display currently programmed duration or
days elapsed since last filter cleaning interval.
(3) Press UP or DOWN sensor to change duration as follows:
0 - 10 - 20 - 30 - 40 - 50 - 60 - 70 - 80 - 90 - 100 - 110 - 120 - OFF
(4) Press DISPLAY sensor once to save changes and return to the
standard water temperature display. Note: If no sensor is pressed
within 30 seconds, the screen will automatically return to the standard
water temperature display.
10.4 Programming Circulation Pump Run Time
The Sentry control system allows you to easily adjust two separate aspects
of circulation pump operation:
1. The time of day (start time) the circulation pump begins operating.
2. The length of time (duration) the circulation pump operates.
The factory default start time is 12:00AM (Midnight). The default duration
is 24 hours. To make adjustments, press the sensor labeled CYCLE five
times to enter the circulation pump programming mode. The LCD screen
will display ADJUST Circ. At this time the system is ready to accept your
changes.
•Press the SELECT sensor once. The previously programmed start time
appears on the LCD display.
•Press UP or DOWN sensors to adjust the start time in 30-minute
increments.
•Press the SELECT sensor to program duration.
•Press UP or DOWN sensors to program the duration time in 1 hour
increments.
CHANGE
FILTER