Filter
Top Products
(Note: This method must be used for the single speed pump (pump #2)
of all Altamar and Marin models because pump #2 is not connected to
the filter.)
IMPORTANT: If freezing conditions exist and pump is not operational,
take measures to protect the system from freeze damage. See
“Winterizing” (page 32).
POOR JET ACTION 1. Make certain the pump is on high speed.
(Figure-F, Page 17) 2. Check position of massage selectors
3. Open air control for selected jet system.
4. Check for adequate water level.
5. Check for dirty filter (page 28-29).
6. Check for dirty filters on all three pump 2
footwell suction covers (page 17).
WATER IS TOO HOT. 1. Reduce thermostat setting (page 14).
2. Reduce skimming/heating cycle length. Even
with heater off, water temperature can increase
from prolonged pump operation (page 25).
NO HEAT 1. Check thermostat setting.
2. Keep the cover in place while heating.
3. If “heater on” indicator is lit (Figure-E, Page 16),
but no temperature rise is experienced after a
reasonable period of time, contact your dealer
or authorized service center.
Should checking the above steps fail to correct the problem, please call your
dealer so that he may arrange service.
Page 39