Servis-Rhino AGM72 Lawn Mower User Manual


 
SAFETY
All Safety Shields, Guards and Safety devices including (but not limited to) - the Deflectors,
Chain Guards, Steel Guards, Gearbox Shields, PTO integral shields, and Retractable Door
Shields should be used and maintained in good working condition. All safety devices should
be inspected carefully at least daily for missing or broken components. Missing, broken, or
worn items must be replaced at once to reduce the possibility of injury or death from thrown
objects, entanglement, or blade contact. (SGM-3)
SAFETY
Replace bent or broken blades with new blades. NEVER ATTEMPT TO STRAIGHTEN,
WELD, OR WELD HARDFACING ON BLADES SINCE THIS WILL LIKELY CRACK OR
OTHERWISE DAMAGE THE BLADE WITH SUBSEQUENT FAILURE AND POSSIBLY
CAUSE SERIOUS INJURY FROM THROWN BLADES.
(SGM-10)
PARTS INFORMATION
Rhino mowers use balanced and matched system components for blade carriers, blades, cutter shafts, knives, knife
hangers, rollers, drive train components, and bearings. These parts are made and tested to Rhino specifications. Non-
genuine "will fit" parts do not consistently meet these specifications. The use of “will fit” parts may reduce mower
performance, void warranties, and present a safety hazard. Use genuine Rhino mower parts for economy and safety.
(SPRM-1)
SEE YOUR RHINO DEALER
Be sure you have adequate knowledge of the property you will be working on. Take time to
make yourself aware of any area underground lines or cables. Contact with buried lines or
cable could result in serious injury or death. (STL-1)
In wet conditions where there is a likelihood of material collecting on the Implement, make
certain that this material is removed before traveling on public roadways. (STL-7)
Storage And Parking Safety Instructions And Practices
A rear Implement can fall if not properly supported. Always use the stand on the front hitch (if
equipped) or block up securely to prevent falling and possible crushing injury and/or other
injury from holding or lifting heavy components. Use the stand to stabilize the implement
during storage. (S3PT-3)
Concluding Safety Instructions and Practices
In addition to the design and configuration of this Implement, including Safety Signs and Safety Equipment, hazard
control and accident prevention are dependent upon the awareness, concern, prudence, and proper training of
personnel involved in the operation, transport, maintenance, and storage of the machine. Refer also to Safety Messages
and operation instruction in each of the appropriate sections of the Tractor and Equipment Manuals. Pay close attention
to the Safety Signs affixed to the Tractor and Equipment. (SG-18)
AGM 52-62-72-82
10/10
Safety Section 1-16
© 2010 Alamo Group Inc.