Filter
Top Products
OPERATION
Storage
If the machine is not used for a long period it is necessary to store it inside to avoid exposure to weather and dust.
Before operating it again, it is good practice to clean the machine and lubricate all components to prevent rust.
• Clean the machine thoroughly;
• Inspect the machine for damaged parts and scratched paint;
• Make sure that safety signs are legible and located properly on the machine. Replace damaged safety labels;
• Replace damaged or worn curtain;
• Lubricate all mechanical components, locking pins, the coupling head to the PTO joint;
• Replace oil in the gearbox and in the cutter bar following the instruction;
• Loose transmission belt, if necessary;
• If possible, store the machine inside and place it on a wooden pallet.
Disposal and Scrapping
The machine shall be scrapped in suitable dumps in compliance with the existing law.
Collect used oil and dispose it according state and local regulations.
Used oil is harmful according to the existing law, therefore it shall be properly collected. Contact the Oil Collection
Centre.
Collect properly plastics, aluminium and steel components for them to be recycled.
Safety Rules for Attaching to the Tractor
Road behaviour, ability to swerve and brake of the tractor also depend upon the equipment mounted.
Select a safe ground speed, in particular when travelling over rough or hilly terrain, in order to avoid upset.
The load on the front axle of the tractor depends upon the weight of the attached mower; the load on the front axle
shall be at least 20 % of empty weight of the tractor.
Before attaching the machine to the three point linkage position the safety device of the tractor to avoid unintentional
raising or lowering of the machine.
Before hitching check lifting and stable operation of the machine referring to the formula in next paragraph.
The three point linkages of the tractor and of the machine shall correspond or be adjusted together.
Rear lifting arms could cause injury. Attach and detach the machine on level ground.
Never use remote control to raise the machine.
In the transport position secure lateral drift arms.
OPERATION
AGM 52-62-72-82
10/10
Operation Section.4-8
© 2010 Alamo Group Inc.