Filter
Top Products
OPERATION
Working Position
To move from the transport position to the work position proceed as follows:
BEFORE STARTING OPERATION, MAKE SURE THERE ARE NO PEOPLE OR ANIMALS
IN THE VICINITY OF THE MOWER.
1. Send the cylinder shaft backwards slightly but keep rope 3 stretched until pin 2 is unlocked. (See Figure 12)
2. Extend the cylinder until the disc carrier bar is horizontal.
3. Lower the mower, fasten adjustment chain 2 to the tractor’s top link support bracket and adjust to maintain the
ground-to-linkage height of 19.7”.(See Figure 13)
4. Lower protection plate and check that the driveline is connected to mower.
OPERATION
Make sure the adjustment chain is always well stretched when machine is working to prevent
pin from being damaged.
AGM 52-62-72-82
10/10
Operation Section 4-30
© 2010 Alamo Group Inc.